ATEQ G620 User Manual

QSG_G620_423.00_EN_01_2020-02-17
PRINCIPLE OF A CYCLE
The measurement cycle is made of 4 main phases: fill, stabilization, test, dumping.
A Pressure auto zero additional phase "5" can be placed at the start or at the end of a
cycle, depending on the requirement of the operator.
1 Fill phase
2 Stabilization phase
3 Test
4 Dumping (option)
5 Pressure auto zero phase
0 Waiting part connection in “Large Leak mode” (blowing air)
1 Fill phase
2 Stabilization phase
3 InfiniteTest time
4 Part is disconnected
5 Pressure auto zero
« START AUTO »
Mode Cycle
« STANDARD »
Mode Cycle
08/34

ATEQ G620 Specifications

General

Brand	ATEQ
Model	G620
Category	Test Equipment
Language	English