ATEQ G620 - User Adjustments; Options of the Menus

QSG_G620_423.00_EN_01_2020-02-17
User adjustments
OPTIONS OF THE MENUS
Different menus are accessible on the MAIN MENU screen.
For more information, refer to the Reference Manual.
SPECIAL CYCLE MENU menu
Use this menu to carry out specific procedures necessary to ensure the proper operation of
measurement cycles (for example, adjustment of pressure regulator).
TO START SPECIAL CYCLES...
1. On the SPECIAL CYCLE MENU screen, select a cycle, and press to
validate.
2. Press Start to execute the cycle.
3. To stop the current cycle press Reset .
PARAMETERS menu
Use this menu to configure the measurement cycle associated to each test program.
Label
Special cycle
Description of the cycle
none
None
No special cycle selected
Regulator adjust.
Regulator adjustment
Test pressure adjustment using front panel
regulator
Piezo auto zero
Piezo auto zero
Pressure and leak AutoZero
PRINT RESULTS
Print results
Print results (infinite test time)
LEAK OFFSET LEARN
Automatic leak offset
learning
Special cycles to determine leak offset
OFFSET+VOL. LEARN
Automatic offset +
volume learning
Special cycles to determine leak offset and
test Volume coefficient using Master leak
Inf Fill
Infinite fill
Pressurize the part with an infinite fill time
Code Reader
Code reader
Bar code learning (bar code reader)
Volume Comp.
Volume compute
Special cycles to determine test Volume
coefficient using Master leak
30/34