ATI Technologies QC-210 User Manual (English)

Other manuals for ATI Technologies QC-210

Questions and Answers:

H
housestephenAug 3, 2025
How to troubleshoot a tool changer that will not lock on my ATI Technologies Industrial Equipment?
- O
  onguyenAug 3, 2025
  If the ATI Technologies Industrial Equipment tool changer won't lock or unlock, or the lock sensor isn't showing a locked state, there might be several reasons: * Check for sufficient air pressure and proper pneumatic valve function to the lock/unlock ports. * Ensure air pressure vents correctly from the de-energized lock/unlock ports. * Inspect pneumatic connections and solenoid cables for damage or looseness. * Remove any debris between the master and tool plates and confirm mounting fasteners are secure. * Clean and lubricate the ball bearings and cam if they're not moving smoothly. * Verify the master and tool plates are within the specified No-Touch zone and re-teach the robot if needed. * Troubleshoot the control/signal module or air/valve adapter.
C
Craig SpencerAug 9, 2025
What to do if the Read-To-Lock (RTL) signal does not read 'on' when the Master and Tool plates are mated on my ATI Technologies QC-210?
- D
  david61Aug 9, 2025
  If the Ready-To-Lock (RTL) signal isn't activating when the master and tool plates are mated on your ATI Technologies Industrial Equipment, it could be due to the tool not being positioned correctly. Try re-teaching the robot to bring the master and tool plates closer together before attempting to lock. Also, inspect the RTL sensors and cables for any damage and ensure the sensor connections to the control/signal module or air adapter are secure. Replace any damaged RTL sensors as needed.
J
Jennifer JimenezAug 15, 2025
Why am I experiencing loss of communication with my ATI Technologies Industrial Equipment?
- R
  Raymond AllenAug 15, 2025
  If you are experiencing a loss of communication with your ATI Technologies Industrial Equipment, check the following: * Inspect the V-ring seal for damage and replace if necessary. * Look for debris around the contact pins. * Check for worn or damaged contact pins. * Ensure cable connections are secure and cables are not damaged.
M
Melissa CampbellAug 21, 2025
What to do if my ATI Technologies QC-210 unit is locked but the lock signal does not read 'on'?
- M
  Mark PhillipsAug 22, 2025
  If your ATI Technologies Industrial Equipment unit is locked, but the lock signal doesn't read 'on', the lock sensor or cable might be damaged. Replace the lock sensor assembly if necessary.
S
sweeneychristopherAug 28, 2025
What to do if my ATI Technologies QC-210 unit is unlocked but the Unlock signal does not read 'on'?
- D
  Dylan SmithAug 28, 2025
  If the ATI Technologies Industrial Equipment unit is unlocked but the unlock signal does not read “on”, the unlock sensor or cable may be damaged. If this is the case, replace the unlock sensor assembly.

ATI Technologies QC-210 Specifications

General

Brand	ATI Technologies
Model	QC-210
Category	Industrial Equipment
Language	English

ATI Technologies QC-210 Manual

Table of Contents

Other manuals for ATI Technologies QC-210

Questions and Answers:

ATI Technologies QC-210 Specifications