Atlas Copco HC 150

Transport using a forklift truck
WARNING Hydraulic attachment tipping over
The hydraulic attachment tipping off the fork of the
forklift truck or the pallet may cause serious injury.
► Do not transport the hydraulic attachment lying on
the fork of the forklift truck.
► Use a rope to hang the hydraulic attachment from
the fork of the forklift truck.
♦
Screw in two adjustable eyebolts diagonally to the
connecting plate of the outer housing (see chapter
Transport using a crane).
♦
Attach ropes or chains to the eyebolts as shown
in the following illustration.
♦
Hang the rope/chain from the fork of the forklift
truck.
♦
Slowly lift the fork until the hydraulic tool is free
from the ground.
♦
Transport the hydraulic attachment to its intended
destination.
♦
Deposit the hydraulic attachment on level ground.
Transport using a truck
WARNING Hydraulic attachment tipping over
/ slipping
The hydraulic attachment slipping or tipping over and
falling from the loading area of a lorry may cause
serious injury.
► Place the hydraulic attachment on an anti-slip mat.
► Secure the hydraulic attachment to the loading
area with ropes or chains; use any available
transport lugs.
♦
Secure the hydraulic attachment to the loading
area as shown in the following illustration.
♦
Observe all the applicable national/regional
regulations on securing loads.
© 2014 Construction Tools EOOD | No. 3390 5121 01 | 2014-11-19
Original instructions
18
HC 150, 350, 450, 850, 1050, 1055TRANSPORT