Starting the engine, Hatz electric start
1. Move the throttle control handle to idling position.
For non EPA throttle control:
Move the throttle control handle to half throttle,
position (A).
For EPA throttle control:
Pull up the stop (B) to release the throttle control
handle. Move the throttle control handle to half
throttle, position (A).
NOTICE The EPA throttle control has three
fixed positions. Make sure the throttle control
handle is in a fixed position.
2. Turn the ignition key (C) to ignition position I. The
control lamps for charging and oil pressure light
up.
3. Turn the ignition key (C) through position II, to
position III.
4. Release the ignition key as soon as the engine
starts. (If the engine has not started in 10
seconds, wait a few seconds before trying again.)
5. Allow the engine to idle for a few minutes.
6. Increase to full power by moving the throttle
control to position (D).
For non EPA throttle control:
For EPA throttle control:
NOTICE If the engine fails to start; turn the ignition
key to position 0, and wait 5 to 10 seconds before
making a new attempt to start.
21© 2016 Construction Tools EOOD | No. 9800 1721 01 | 2016-04-07
Original instructions
Safety and operating instructionsLG 504
To Next Page
Loading...
