4. Pull out the starter rope (D) until it resists.
Release the handle so the starter rope goes back
again, and then pull the starter rope until the
engine starts.
5. Now gradually open the choke (E) until it is fully
open.
6. Allow the engine to idle for a few minutes before
increasing to full power.
Stopping the engine
1. Set the throttle, engine switch, and fuel tap
control (A) in the stop position.
Operating
NOTICE During operation, the engine must always
work at full throttle (working mode).
NOTICE When operating in narrow trenches, there
is a risk of the rammer leg fastening between the
trench walls. The rammer can then miss-strike and
become damaged. The rammer shoe in particular
could be severely damaged. When operating in
trenches, make sure that they are wide enough
before starting.
♦
Operate the rammer on a level surface.
♦
Never operate on hard surfaces (solid rock,
hardened concrete etc).
♦
Steer the machine with the handle.
♦
Excessive pressure on the handle will result in
poor compaction by obstructing the vibratory
action.
♦
The rammer must not be pressed down into the
material being compacted.
♦
If the machine tips over during operation, switch
off the engine before lifting it up.
Start label
A. Working mode.
B. Start and idling.
C. Stop, transport, and refuelling.
© 2015 Construction Tools EOOD | No. 9800 1415 01b | 2015-05-26
Original instructions
18
LT 6005Safety and operating instructions
To order go to Discount-Equipment.com
To Next Page
Loading...
Need help?
General
