Checking the oil level in the spring-loaded
leg
Check the oil level in the spring-loaded leg through
the sight glass (A).
The level must be at the middle of the sight glass
when the machine is in the upright position.
Check and clean the air filter
Check and clean the air filter (A).
Checking bolted joint
Check and if necessary tighten screws and nuts.
After the first 20 hours of
operation
The following maintenance must be performed after
the first 20 hours of operation:
♦
Change the engine oil.
♦
Replace air filter.
♦
Change the oil in the spring-loaded leg.
♦
Check the engine speed.
♦
Tighten the bolt joints on the rammer shoe.
21© 2015 Construction Tools EOOD | No. 9800 1415 01b | 2015-05-26
Original instructions
Safety and operating instructionsLT 6005
To order go to Discount-Equipment.com
To Next Page
Loading...