Operator’s instructions
6. Before drilling
68
Figure: Rear control panel
1. Unlock the track oscillation using the track oscillation lever (1).
2. Align the drill rig horizontally using the track oscillation lever (8).
3. Set the track oscillation lever to BOTH CYLINDERS CLOSED position.
4. Lower the jack to the ground.
5. Raise the feed beam fully using the feed extension cylinder.
6. Position the feeder.
7. Set the feed spike firmly against the ground without lifting the drill rig by
manoeuvring the levers for boom lowering and feed extension alternately and in
steps.
Note
Do not lift the drill rig with the feeder!
To Next Page
Loading...
