- 38 -
If a special status has elapsed, the active view will be
entered again automatically.
If an Alarm comes up, the Alarm Display is shown.
Line voltages generator display
This view shows the line voltages of the generator.
Controller type and version display
This view shows the controller type and the ASW
version number.
Parameter display
This view shows a number of Parameter settings and
gives access to them.
An overview is given in “Parameter list” on page 40.
Alarm list display
This view shows the number of active alarms and
gives access to them.
An overview is given in “Alarm overview” on
page 83.
LOG list display
This view shows the alarm memory and gives access
to it.
An overview is given in “LOG list” on page 45.
Service timer 1 & Service timer 2 display
This view shows both Service timers. The service
timer indication is shown when service time has run
out. It can be removed by resetting the timers or
acknowledging the Service timer indication.
The service timer indications count and give an alarm
when value is reached.
Resetting the Service Timers can be done through the
Parameter display.
DIAGNOSTIC
To Next Page
Loading...
