- 18 -
2. Open the door of the control panel and start the
engine as described in “Electric start-up procedure
for the lighting tower” and “Starting the engine”
on page 13. (If there is no fuel, there will be a
message on the display and an acoustic alarm.)
3. Put the general circuit breaker to the ON position
(2) and all other switches to the OFF position (3).
4. Use the UP (4) and DOWN (5) buttons on the
control panel to extend and adjust the mast to the
desired height (max 9 metres). When the mast is
being extended/lowered, an intermittent sound
will signal that the operation is in progress.
5. Release the locking pin (6) and the clutch locking
lever (7) of the mast (located on its rotating base)
and rotate the lighting tower using the handles
provided for this purpose (8) to further adjust the
light beam. The mast can be rotated through 350°.
6. Lock the mast again using its locking pin (6) and
lever (7).
Switching on the spotlights
1. Place the 4 automatic switches (LAMP 1, LAMP
2, LAMP 3 and LAMP 4) in the ON position (1).
2. Wait for the lights to heat up. This will take about
2-3 minutes.
3. Close the control panel door (2).
Switching off the spotlights
To switch the lights off, follow the procedure
described in “Switching on the spotlights” but in the
reverse order and proceed to lower the mast.
1. Open the control panel door.
2. Position the 4 automatic switches (LAMP 1,
LAMP 2, LAMP 3, LAMP 4) to the OFF position
(1).
3. Wait for the lamps to cool down - this will take
around 15 minutes.
4. If the spotlights are not to be used again, lower the
mast using the DOWN button on the control panel
(2).
To Next Page
Loading...
