- 19 -
5. The mast is lowered completely when the end-of-
run button (3) is pushed down and the intermittent
siren stops.
Positioning for transportation
1. Push the DOWN button on the control panel (1) to
lower the mast. The mast is lowered completely
when the end-of-run button is pushed down and
the intermittent siren stops.
2. Make sure that the jockey wheel is safely fastened
by its own locking lever (2) to ensure that the
lighting tower is still stable once the stabilizing
feet are removed. Adjust the height of the jockey
wheel using the crank (3). The jockey wheel
should never touch the ground once the lighting
tower is coupled to the hook of the towing vehicle
(4).
3. Use the handle at the top of each foot to retract the
4 feet following the reverse order of the procedure
described in numbers 2-3-4-5 in “Unhooking the
lighting tower” on page 16. The feet must be
stowed as shown below.
Once all the above operations are complete, you will
have returned the lighting tower to the same state as it
was before the positioning procedure (see figure
above). At this point the lighting tower is correctly
arranged for transportation.
Once the lights are switched off
(switches in the OFF position),
remember not to switch them ON
again until the cooling-off time is
over.
If you do not wish to use the
generating set on its own, switch off
the engine (and therefore the
machine) as described on page 14.
To Next Page
Loading...
