- 7 -
Lighting tower mast
– Do not deploy the mast unless the machine is
standing on an even surface and the stabilizers
have been fully adjusted (see “Positioning the
lighting tower” on page 16).
– Do not deploy the mast if the wind is stronger than
90 Km/h.
– Do not deploy the mast in the vicinity of overhead
power cables: DANGER OF
ELECTROCUTION.
– Make sure that nobody is standing too close to the
lighting tower when the mast is being deployed.
– Make sure that the lighting tower has been earthed
by means of the relevant device (earth rod).
– Do not operate the lighting tower if the machine's
electrical isolation system is defective or if the
electric wires are worn or not properly insulated.
– Do not switch on the spotlights without their
protective lenses or if the lenses are cracked or
damaged.
To Next Page
Loading...
