►
Keep your hands away from the start and stop
device until you are ready to start the machine.
►
Learn how the machine is switched off in the
event of an emergency.
►
Release the start and stop device immediately
in all cases of power supply interruption.
►
Whenever fitting or removing the insertion tool,
switch off the air supply, bleed the machine by
pressing the start and stop device and
disconnect the machine from the power source.
WARNING Noise hazard
High noise levels can cause permanent and
disabling hearing loss and other problems such as
tinnitus (ringing, buzzing, whistling, or humming in
the ears). To reduce risks and prevent an
unnecessary increase in noise levels:
►
Risk assessment of these hazards and
implementation of appropriate controls is
essential.
►
Operate and maintain the machine as
recommended in these instructions.
►
Select, maintain and replace the insertion tool
as recommended in these instructions.
►
If the machine has a silencer, check that it is in
place and in good working condition.
►
Always use hearing protection.
►
Use damping material to prevent work pieces
from 'ringing'.
Maintenance, precautions
WARNING Machine modification
Any machine modification may result in bodily
injuries to yourself or others.
►
Never modify the machine. Modified machines
are not covered by warranty or product liability.
►
Always use original parts, cutting blades/
working tools, and accessories.
►
Change damaged parts immediately.
►
Replace worn components in good time.
CAUTION Hot working tool
The tip of the working tool can become hot and
sharp when used. Touching it can lead to burns
and cuts.
►
Never touch a hot or sharp working tool.
►
Wait until the working tool has cooled down
before carrying out maintenance work.
WARNING Insertion tool hazards
Accidental engagement of the start and stop
device during maintenance or installation can
cause serious injuries, when the power source is
connected.
►
Never inspect, clean, install, or remove the
insertion tool while the power source is
connected.
Storage, precautions
◆
Keep the machine and tools in a safe place, out
of the reach of children and locked up.
Safety and operating instructions SRD 20, 25
10 © Construction Tools PC AB | 9800 1883 01 | 2017-05-31
Original instructions
To Next Page
Loading...
Need help?
General
