- 52 -
Maintenance schedule (running hrs)
(continuation of page 51)
Daily 50 hrs after initial
start-up
Every
500 hrs
Every
1000 hrs
Every
2000 hrs
Ye ar ly
Adjust engine inlet and outlet valves (2) x x x
Check functioning of regulating valve xxx
Test safety valve (9) xxx
Replace bleed-off valve unloader xxx
Check rubber flexibles (10) xxx
Replace DD/PD/QD filter (option) xxx
Clean oil stop valve xxx
Change compressor oil (1) (7) xxx
Replace oil separator element xxx
Replace air filter element (1) xxx
Inspection by Atlas Copco service technician xxx
Grease hinges x
Check emergency stop x
Analyse coolant (4) (8) x
Check/Replace safety cartridge x
Inspect starter motor x
Inspect turbocharger x
Inspect waterpump x
Inspect alternator x
Check/Clean diesel particulate filter (2) (12)
(to be continued on page 53)
To Next Page
Loading...
