- 36 -
The display now shows After warming up the machine is ready to be loaded and is
waiting for a load command; the display shows
Press the load button, the display will show
When the load button is pressed and the measured vessel
pressure is lower then 4.5 bar, the controller will run a
specific program to reach the requested 4.5 bar, in order to
be able to load the machine. (Only applicable for 2-stage
machines).
Active Buttons
Stop Button
(to cancel Start command)
Load Button
(to cancel Load command)
Measurement View Button
Settings View Button
Alarms View Button
MAIN VIEW
ENGINE WARMING UP
1200RPM 2.9 bar41% 1286h
15s
7s
0s
Active Buttons
Stop Button
(to cancel Start command)
Load Button
(to cancel Load command)
Measurement View Button
Settings View Button
Alarms View Button
MAIN VIEW
READY TO LOAD
4.6
1200RPM 4.6bar41% 1286h
Active Buttons
Stop Button
(to cancel Start command)
Load Button
(to cancel Load command)
Measurement View Button
Settings View Button
Alarms View Button
MAIN VIEW
BUILDING UP VESSEL PRESSURE
3.9
1200RPM 3.9bar41% 1286h
To Next Page
Loading...
