Operators Manual ATLAS CARTS
12
S E C T I O N
2
Operators Manual ATLAS CARTS
Safety First
Vehicle Safety and
Compliance Decals
Take note of the various Safety Decals that are located in and around the
vehicle. Be sure to follow all the instructions on the safety decals to prevent
the risk of accidental death, serious personal injury, or property damage.
When cleaning the vehicle, do not use solvents, gasoline, or other chemicals to
clean the decals. Do not pressure wash decals. Instead, use a soft moist cloth
to gently remove any accumulated dirt that may obscure the information printed
on the decals.
Make sure all of the safety and operation decals are in the correct locations
as placed by the manufacturer. Do not remove any of the safety decals.
Always replace any safety and operation decals that are missing or damaged.
1
2
SERIOUS INJURY OR DEATH MAY OCCUR WITH UNINTENDED
MOVEMENT, COLLISION, ROLLOVERS OR FALLING OUT FROM VEHICLE
MAXLOAD: 2P = 500 lbs. MAX GRADE:20%
4P = 900 lbs.
•Only authorized and/or licensed personnel should operate this vehicle
•All operation should follow in compliance with local and state laws
•Unpaved surfaces, high traffic areas and driving near higher speed vehicles should be
done with cauton
•Do not obstruct traffic with operation of this vehicle
WARNING
•All occupants should be fully seated before the start and operation of this vehicle
•Maximum occupants per bench seat is two (2)
•Only driver side occupant should operate this vehicle
•Children should not be unattended with vehicle at any time
•Slower speed should be used when making turns and driving on inclined/declined surfaces
•Occupants should keep entire body secure within vehicle while vehicle is in motion
•This vehicle should not be operated under the influence of drugs or alcohol
•This vehicle should not ne operated when distracted
OPERATING INSTRUCTIONS
Users should read the vehicle manual and safety warnings to fully understand vehicle operation before use.
·Turn wheels in the direction of a clear path.
·Tu rn key to the ON position
·Only sh ift to forward or reverse when vehicle is completel y stoppe d
·Pressing on accelerat or pedal w ill caus e vehicle to move
·To increase vehicle speed, gradua lly pres s accele rator pe dal
·Release accelerator p edal and p ress dow n brake pe dal to “br ing”
vehicle to full sto p
Severe injury or death may occur with unintended vehicle movement!
·Make sure parking brake is engaged when not in operation
·Vehicle should be place in N eutral w hen park ing
·Turn key to the o positi on and rem ove from key hole when not in operation
WARNING!
To Next Page
Loading...