Installation 26
Kwik Bay
7.7 Checks Less Load
During this procedure, observe all operating components and
check for proper installation and adjustment. DO NOT attempt
to raise vehicle until a thorough operation check has been
completed.
Carry out two or three complete cycles of lowering and lifting and check:
• the safety devices for proper operation
• proper oil level in the tank
• no leakage and blow-by in hydraulic line and pneumatic line
• cylinder for proper operation
• the lift for reaching its maximum height
• the horn/signaling light for proper operation during the fi nal travel
7.8 Checking With Load
WARNING: The lift must be raised at least 12” out of the
ground before taking the load.
It is extremely forbidden to load the vehicle when the lift wheels
are on the lift. Failure to do so can damage the lift severely.
Carry out two or three complete cycles of lowering and lifting and check:
• Repeat the 7.7 section
• Check no strange noise during lifting and lowering
To Next Page
Loading...
Need help?
General
