Atmel ATmega48A User Manual (English)

To Next Page

To Previous Page

8271D–AVR–05/11

ATmega48A/PA/88A/PA/168A/PA/328/P

• Bit 2 – PRSPI: Power Reduction Serial Peripheral Interface

If using debugWIRE On-chip Debug System, this bit should not be written to one.

Writing a logic one to this bit shuts down the Serial Peripheral Interface by stopping the clock to

the module. When waking up the SPI again, the SPI should be re initialized to ensure proper

operation.

• Bit 1 – PRUSART0: Power Reduction USART0

Writing a logic one to this bit shuts down the USART by stopping the clock to the module. When

waking up the USART again, the USART should be re initialized to ensure proper operation.

• Bit 0 – PRADC: Power Reduction ADC

Writing a logic one to this bit shuts down the ADC. The ADC must be disabled before shut down.

The analog comparator cannot use the ADC input MUX when the ADC is shut down.

Need help?

Do you have a question about the Atmel ATmega48A and is the answer not in the manual?

Atmel ATmega48A Specifications

General