65
ATtiny15L
1187H–AVR–09/07
Note: 1. “Max” means the highest value where the pin is guaranteed to be read as low.
2. “Min” means the lowest value where the pin is guaranteed to be read as high.
3. Although each I/O port can sink more than the test conditions (20 mA at V
CC
= 5V, 10 mA at V
CC
= 3V) under steady state
conditions (non-transient), the following must be observed:
1] The sum of all I
OL
, for all ports, should not exceed 100 mA.
If I
OL
exceeds the test condition, V
OL
may exceed the related specification.
Pins are not guaranteed to sink current greater than the listed test conditions.
4. Although each I/O port can source more than the test conditions (3 mA at V
CC
= 5V, 1.5 mA at V
CC
= 3V) under steady state
conditions (non-transient), the following must be observed:
1] The sum of all I
OH
, for all ports, should not exceed 100 mA.
If I
OH
exceeds the test condition, V
OH
may exceed the related specification. Pins are not guaranteed to source current
greater than the listed test condition.
5. Minimum V
CC
for Power-down is 1.5V (only with BOD disabled).
V
ACIO
Analog Comparator
Input Offset Voltage
V
CC
= 5V
V
IN
= V
CC
/2
40.0 mV
I
ACLK
Analog Comparator
Input Leakage Current
V
CC
= 5V
V
IN
= V
CC
/2
-50.0 50.0 nA
T
ACID
Analog Comparator
Initialization Delay
V
CC
= 2.7V
V
CC
= 4.0V
750.0
500.0
ns
DC Characteristics (Continued)
T
A
= -40°C to 85°C, V
CC
= 2.7V to 5.5V
Symbol Parameter Condition Min Typ Max Units
To Next Page
Loading...
Need help?
General
