ATN Mars 2 - Page 51

C-2
12±0.3
M
8 10
5. Loosen Nut (8) of Subassembly (9) (reticle screw) and release
reticle screw from Item (10) of Subassembly (11) (Figure C-2).
FIGURE C-2
6. Use Wrench CT.00.03.000 to take out Thread Ring (12).
7. Draw Tube Holder Subassembly (11) out of the scope body.
C-2. TUBE HOLDER REASSEMBLY WITH TUBE
1. Set 37 mm image intensifier tube IIT pre-assembled with IIT
Container (13) onto sealant.
2. Follow up Figure B3 to calculate the total thickness of the
Compensation Ring (14) and trim it.
FIGURE C-3
8.3
-0.2
B
A
C
C=8.3-A-B