4. The laser itself has a protective cover, the protective cover is fastened by screws. When the laser is installed on the laser engraver, the
protective cover should be checked to be reliably locked, and can not be removed in the energized state.
5. The housing of the laser engraver have an interlock function. When the housing is opened or removed, the laser can be automatically turned
off.
6. The laser engraver have an emergency stop button, which can immediately stop the output of the laser when pressed under unexpected
circumstances.
7. The laser engraver have a reset button, which can resume work under the condition of confirming safety after lifting the interlock or
emergency stop.
8. Laser engraver use physical keys, dongle, password system and other ways to manage and control, to prevent personnel without security
training operation of this kind of equipment.
9. On the laser engraver any window or channel that can actively observe or passively receive the laser radiation set up warning marks.
10. If the laser burns the skin or eyes, please go to a nearby hospital for examination and treatment immediately.
To Next Page
Loading...
Need help?
General
