Instructions for exporting nc and gc format files
1.Import the picture to be engraved or cutted into laserGRBL, after
setting the engraving speed and energy parameters etc., click File, and
select Quick Save
1.laserGRBL software
2.Select sd chuck as the save path, click Save to generate
nc file.
1.Import the picture to be engraved or cutted into
lightburn, after setting the engraving speed and energy
parameters etc., click Save Gcode.
2.lightburn software
2.Select TF chuck as the save path, click Save to generate
gc file.
To Next Page
Loading...
