TROUBLESHOOTING AND SERVICE REQUIREMENTS
|
96
320-HOUR SERVICE REQUIREMENTS
This service must be performed to keep warranty active.
Engine oil and filter must be changed every 50 hours. Please see your dealer.
ATX MAINTENANCE SCHEDULE DA I LY WEEKLY REGULAR ANNUAL
EVERY 2
YEARS
300-
HRS.
Smell bilge area for fuel vapors
Check and tighten all steering
system bolts and connections
Check rudder, tiller arm bolt
and safety setscrew
Lubricate rudder stuing box
and steering support tube
Lubricate cables
Replace cables If stiness continues after lubricating
Check bilge pump operation
Check blower operation
Inspect shaft seal
Check shaft alignment/ensure
it is within .003
Check and tighten motor
mounts
Tighten pylon and tower
mounting bolts
Tighten all hardware and
fasteners
Change engine oil and filter
(every 50 hrs. or annually)
Change transmission fluid every
300 hrs.
Change engine coolant
Check engine oil
Check transmission
Check water pickups for debris
or marine growth
If equipped with a strainer,
check and clean
If operated in salt water, flush
engine/cooling system and boat
IF PROPELLER STRIKES AN OBJECT, INSPECT DRIVE TRAIN IMMEDIATELY!
500-HOUR SERVICE REQUIREMENTS
This service must be performed to keep warranty active.
Engine oil and filter must be changed every 50 hours. Please see your dealer.
ATX MAINTENANCE SCHEDULE DA I LY WEEKLY REGULAR ANNUAL
EVERY 2
YEARS
500-
HRS.
Smell bilge area for fuel vapors
Check and tighten all steering
system bolts and connections
Check rudder, tiller arm bolt
and safety setscrew
Lubricate rudder stuing box
and steering support tube
Lubricate cables
Replace cables If stiness continues after lubricating
Check bilge pump operation
Check blower operation
Inspect shaft seal
Check shaft alignment/ensure
it is within .003
Check and tighten motor
mounts
Tighten pylon and tower
mounting bolts
Tighten all hardware and
fasteners
Change engine oil and filter
(every 50 hrs. or annually)
Change transmission fluid every
300 hrs.
Change engine coolant
Check engine oil
Check transmission
Check water pickups for debris
or marine growth
If equipped with a strainer,
check and clean
If operated in salt water, flush
engine/cooling system and boat
IF PROPELLER STRIKES AN OBJECT, INSPECT DRIVE TRAIN IMMEDIATELY!
To Next Page
Loading...