AU E10K - Answer Memo Function

19
Making and Answering Calls
Adjusting the Incoming Ring
Tone Volume
When the standby screen is displayed, press c.
Use ➡ a to select Set Functions and then press
c (Select).
Use ➡ j to select Tone/Vib/Lamp and then press
c (Select).
Use ➡ j to select Incoming Setup and then press
c (Select).
Use ➡ j to select Incoming Call and then press
c (Select).
Use ➡ j to select Volume and then press
c (Select).
Use ➡ j to adjust the volume and then press
c (OK).
Each press of • j changes the volume one step.
STEP UP
The ring tone volume gradually increases.
5 (Deka)
(loud)
󱽘
1 (sof
t)
The ring tone sounds at the set volume.
OFF
The ring tone does not sound.
Turning On the Answer Memo
When the standby screen is displayed, hold down
C for at least one second.
is displayed on the standby screen.
■ Turning Off the Answer Memo
When the standby screen is displayed, hold down C for
at least one second. The answer memo is turned off and
disappears from the standby screen.
The cell phone can record a maximum of ten •
messages, each up to 60 seconds long.
Answer memo is a function that automatically answers •
calls and allows callers to record messages. Use the
Answering Service (Voice Mail) when your phone is
turned off or when you are in a location where a signal
cannot be received.
■ Playing a Message
If a message is recorded, AnswerMemo appears on
the standby screen.
Use ➡ j to select AnswerMemo and then press
c (Check).
Use ➡ j to select Play Memo and then press
c (Select).
Use ➡ j to select the message you want to play
and then press c (Play).
To stop playing the message, press • c (Stop).