• .___ H_ o_m_ e_L_·_,n_k_® __________________________________________________ _
- Press the appropriate programmed button 0 , @ or @
to activate the desired remote control function ~
& in
"General information" on
page 139. •
App li es to vehicles: with Homelink® universal remote contro l
Reprogramming a single button
A HomeLink® button can be reprogrammed individually
without affecting the other button a/locations.
Programming the overhead keypad
- Press the appropriate Homelink® button until the indi-
cator light begins flashing slowly.
Programming the bumper mounted transmitter
1. Hold t he
original remote control at a distance between 0-
5 in. (0-13 cm) from the bumper below the appropriate
headlight for your vehicle (use the shortest distance
possible).
2. Aim the remote control just below the
driver side head-
light.
3. Press and hold the activation button on the remote
control.
4. The emergency flashers will flash
three times (after
about
15-60 seconds) when the programming is
successful. Now release the button on the remote
control.
- If the device utilizes a rolling code, please follow phase 3
of ~
page 140, "Programming the Home link® trans -
mitter" for rolling code programming.
This procedure will cause the existing programming on the
Homelink ® button to be erased! •
Appli es to vehicles: wit h Homelink® unive rsal remote contro l
Erasing the programming of the Homelink ®
transmitter
When you erase the programming, the programming on
all three of the transmitter channels with be lost!
- Perform steps 1 to 4 as described on ~ page 140, "Phase
1: programming the overhead keypad".
When completed , the Homelink® system will be in the prog ram-
ming mode and is then ready to learn the codes for remote
controlled devices.
[I) Tips
• Programmed buttons cannot be erased individually.
• For security reasons you are advised to erase the programming
of the Homelink ® system befo re you sell your vehic le. •
To Next Page
Loading...
