Defective light bulb warning
The defective light bulb warning tells you when a vehicle
light bulb has become defective.
If a defective bulb has been detected by the system or a light bulb
burns out, the symbol with a message appears in the display to
tell you which bulb is burnt out and where it is located. For example:
Rear left tu rn signal
After 5 seconds, the message disappears . If you want to reca ll the
message into the display, press the CHECK button .
There are three reasons why the defective bulb message would
appear in the display:
• the light bu lb has burnt out ~
page 302 .
• the fuse is "blown"~ page 300, "Replacing a fuse" .
• the wire connection to the light bulb is defective .
Have the bulb replaced or the connection repaired by your autho-
rized Audi Service department .
& WARNING
• Light bulbs are pressurized and could explode while they are
being changed causing serious personal injury.
• Work with due care when handling the high-voltage sect ion of
gas discharge !xenon ) lamp s* . Failing to do so could result in death
or seriou s injury! •
Contro ls and equip-
ment
Dri ve r informa t io n di s pl a y
Speed warning system
Overview
The speed warning system helps you to keep your driving
speed below a set speed limit.
Fig. 19 Display: speed
wa rning syst em
The speed warning system warns the driver if he exceeds a previ -
ously stored maximum speed . A warning tone wi ll sound as soon as
the vehicle speed exceeds the set speed by about 3 miles per hour
(3 km/hl. At the same time, a warning symbo l appears in the display
~fig.19.
The speed warning system has
two w arning thre sholds that func-
tion independently of each other and t hat have somewhat different
purposes :
Speed warning 1
You can use speed warning 1 to set the maximum speed while you
are driving . This setting will remain in effect unt il you turn off the
ignition, assuming that you have not changed or reset the setting.
The speed warning symbol
C-~ (USA models)/ (Canada models) in
the warning 1 display appears when you exceed the maximum
speed . It goes out when the speed falls below the stored maximum
speed. .,
~ehicle care Technical data
To Next Page
Loading...
