Savin g a m a ximum s p e ed
- Turn off the ignition .
Fig. 22 Wiper arm :
function selector
switches
- Briefly press the CHECK button in the instrument cluster
=> page
36, fig. 21. The odometer and the digital clock
will now be illuminated.
Press the CHECK button for at least two seconds. The
currently stored maximum speed
or the crossed out
symbol for warning 2 wi ll appear in the display if a
maximum speed has not yet been set.
Press the function selector switch in the wiper arm @
=> fig. 22 up or down to change the set value . The values
increase or decrease in increments of 6.2 mph (10 km/h).
R e s e tting th e m a ximum sp ee d
- Turn off the ignition .
- Briefly press the CHECK button in the instrument cluster
=> page 36, fig. 21. The odometer and the digital clock
will now illuminate briefly .
- Press the CHECK button for at least two seconds. The
cu rrently stored maximum speed will appear in the
disp lay.
Contro ls and equip-
ment
Dri ve r informa t io n di s pl a y
- Press t he rese t button in the wiper arm @ => fi g. 22 until
t he d isplay shows the symbol f or spe ed warning 2
crossed out w ith a line .
The odometer and the digital clock disp lays wi ll go out again a few
seconds after this adjustment is completed . •
Trip computer
Introduction
The trip computer gives you information on current and
average fuel mileage, average speed, fuel range and
driving time.
Fig. 23 Trip computer
display: Average fuel
mileage
You can switch between the trip computer 1 and 2 by pressing the
Reset button
@ => page 38, fig. 24
You can tell which memory level is currently active by the number in
the display => fig. 23. The data from the single -trip memory
(memory level 1 l is being displayed if a
1 appears in the display. If a
2 is shown, then the data from the total -trip memory is being
displayed (memory leve l 2). ..,_
~ehicle care Technical data
To Next Page
Loading...
