Dri ve r inf o rma t ion d is pl a y
The speed warning symbol will also go out if the speed exceeds the
stored maximum speed by more t han about 25 mph (40 km/h) for at
least 10 seconds. The stored maximum speed is de leted .
Setting speed warning 1
~
page 36.
Sp eed w ar ni ng 2
Storing warning 2 is recommended if you
always want to be
reminded of a certain speed, for example when you are traveling in
a country that has a general maximum speed limit, or if you do not
want to exceed a specified speed for winter tires.
The speed warning 2 symbol,
~
(USA models)/ :, (Canada models)
appears in the disp lay when you exceed the stored speed limit.
Unlike warning 1, it will not go out until the vehicle speed drops
below the stored speed limit.
Setting speed warning 2
=> page 36.
[ i ) Tip s
Even though your vehicle is equipped with a speed warning system,
you should still watch the speedometer to make sure you are not
driving faster than the speed limit . •
Speed warning 1 : setting a speed limit
Warning threshold 1 is set by the CHECK button.
I 52YY
0
N
"'
:8
i
00
"'
Fig . 20 CHECK but t on
in th e instr ume nt
clu ster
Storing th e maximum speed
- Drive at the desired maximum speed.
- Briefly press the CHECK button
=> fig . 20.
R e s e tting th e m a ximum s pe e d
- Drive the veh icle at a speed of at least 3 mph (5 km/h)
- Press the CHECK button for at least two seconds.
The speed warning symbol _ f __ (Canada models) appears briefly
in the display when you release t he button to indicate that the
maximum speed has been stored successful ly. The maximum speed
wi ll remain stored in the system until it is changed by briefly
pressing the button again or unti l it is reset by holding down the
button for at least two seconds. •
Speed warning 2 : setting a speed limit
Switches in the wiper arm are used to operate warning
threshold 2.
I 52YY
0
Fig. 21 CHECK butt on
in the inst rum ent
clu ste r .,,.
To Next Page
Loading...
