In st rum e n t s and warnin g/ indi ca t o r lig h ts
M a lfu nc ti o n message
If there is a malfunction somewhere in the inst rument cluster, dEF
will appear in the trip odometer and will stay on. Contact your
authorized Audi dea ler to have the prob lem corrected.
Im mob ilizer
Each time you switch on the ignition, the data stored in the vehicle
key are electronically scanned to verify that key data and vehicle
data match. If a non -coded or a defective vehic le key is used, the
word
SAFE wi ll appear and remain lit in the upper (trip) odometer
display . If this happens, the vehicle cannot be started =>
page 49. •
Fuel gauge
The fuel gauge works only when the ignition is on .
When the needle reaches the red area, the warning light in the
instrument cluster wil l illuminate =>
page 33 [) . This means you
have approx imately 2.4 gallons (9 liters) of fuel left in the tank.
Time
to refuel!
The total tank capacity of your vehicle is listed in => page 314.
0 Note
Never run the tank completely dry! An irregular supply of fuel can
cause engine misfiring and fuel could enter into the exhaust
system. The catalytic converter could then overheat and be
damaged. •
[ C HE CK] button
You can perform different functions with this button.
I S2YY
0
Fig. 6 CHECK butto n in
th e inst rument clust er
The [ CHECK] button performs the following functions:
Swi tch in g on t he cl o c k and o dome te r
With the ignition is switched off, the odometer and digital clock with
date disp lay can be switched on for a few seconds by pressing the
[CHECK] button=> fig. 6.
St a r t in g t h e A ut o- Che c k se qu e n ce
The Auto-Check system=> page 28 consistently monitors certain
individual functions and componen t s of the vehicle when the igni-
tion is turned on and when the vehicle is moving.
With the ignition switched on, you can start the" Auto-Check
sequence" by pressing the [
CHECK I button. You can perform an
Auto -Check sequence both when the vehic le is at a standstill and
the ignition is switched on or when the veh icle is mov ing not faster
than 3 mph (5 km/h).
Ca lling u p th e dri ve r inform ati on
When a first priority symbol starts to flash => page 28 or when a
defective light bu lb=>
page 35, has been detected, you can press
the
! CHECK] button to display the driver information. For example:
Switch off engine and check oil level
To Next Page
Loading...
