__________________________________________________ T_ ir_e_s_ a_n_d_ w_ h_e_ e_l_s_ ...... ffllll
•
Tire manufacturing date
The manufacturing date is also indicated on the tire sidewall
(possibly on ly on the
inner side of the wheell:
"DOT ... 2209 ... " means, for example, that the tire was produced in
the 22th week of 2009.
Speed rating (letter code )
The speed rating letter code on the wheels indicates the maximum
permissible road speeds =:,
& in "Winter tires" on page 284.
P up to 93 mph (150 km/h)
Q up to 99 mph (158 km/h)
R upto 106mph(170km /h)
S upto110mph(180km/h)
T upto118mph(190km/h)
U up to 124 mph (200 km/h)
H upto130mph(210km/h)
V up to 149 mph (240 km/h)
31
Z over 149 mph (240 km/h)
3
l
W up to 168 mph (270 km/h)
31
Y up to 186 mph (298 km/h)
3
l
Your vehicle is normally factory equipped with tires, which possess
excel lent driving characteristics and give your Audi opt imum
driving comfort. An electronic speed limiter=:, page 28will normal ly
prevent your vehicle from going faster than the tire speed ratin g
=:>&.
U.S. DOT Tire Identification Number (TIN ) and tire
manufacture date
This is the tire's "serial number". It begins with the letters "DOT"
and indicates that the tire meets all federal standards. The next two
numbers or letters indicate the plant where it was manufactured,
and the last four numbers represent the week and year of manufac-
31
For t ires with a maximum speed capability over 149 mph (240 km/h), tire
manufacturers so metimes use the letters "ZR."
ture. For example, the numbers 2209 mean that the tire was
produced in the 22th week of 2009. The other numbers are
marketing codes that may or may not be used by the tire manufac-
turer . This information is used to contact consumers if a tire defect
requires a recall.
Tire ply composition and materials used
The number of plies indicates the number of layers of rubber-coated
fabric in the tire. In general, the greater the number of plies, the
more weight a tire can support. Tire manufacturers also must indi -
cate the materials in the tire, which include steel, nylon, polyester,
and others.
Maximum Load Rating
This number indicates the maximum load in kilograms and pounds
that can be carr ied by the tire .
Tire quality grading for treadwear, traction, and
temperature resistance
Tread wear, traction and temperature grades=:, page 283.
Maximum Permissible Inflation Pressure
This number is the greatest amount of air pressure that should ever
be put in the tire under normal driving conditions.
Replacing tires or rims on vehicles equipped with tire
pressure monitoring system*
The wheels on your vehicle are equipped with a sensor which
constantly monitors the air pressure inside the tire, and then trans -
mits this information to the tire pressure monitoring system*. If you
are going to replace the wheel rims on your vehicle, make sure the
new rims also have these sensors . The sensors must be compatible
with the tire pressure monitoring system* on your vehic le.
If you install rims, which do not have the sensors, or have sensors
which are not compatible, then the tire pressure monitoring
system* wil l not work properly. In this case, the tire pressure moni - .,_
Vehicle care
To Next Page
Loading...
