Inserting the release key into the locking
mechanism
- The release key must be configured for insert ion
=>
page 69, f ig. 66. Turn the red handle segment counter -
clockwise to the stop to configure the key for insertion.
- Insert the release key int o the hole in the roof of the ski
sack tunnel :::>
page 70, fig. 69 .
- Turn the release key either way until you can feel the lugs
at the tip of the key engage inside the locking mecha-
nism.
- Rotate the release key a quarter turn clockwise to the
stop . The release key is now
hanging engaged in the
locking mechanism of the storage bay cover :::>
page 70,
fig . 70.
Unlocking the storage bay cover
- Turn the red handle segment on the release key clock-
wise until it you can hear it engage.
- Turn the entire release key counter -clockw ise to the stop.
This unlocks the storage bay cover. It will spring up
slightly out of the latches :::>
page 70, fig. 71. •
Contro ls and eq uip-
ment
Power top
Step 3 : Opening the storage bay cover
The storage bay cover must now be folded up to the stop.
Fig. 72 Opening the
storage bay cover
- Pull up the storage bay cover :::> f ig . 72.
- Open the storage bay cove r as far as it will go. It will stay
open by itself in t he upright position =>& .
& WARNING
Make absolutely sure that the storage bay cover is opened all the
way to the upright position. It will stay open in this position by
itself .
If it is not lifted up to the fully open position, the storage bay
cover can drop back down onto you or another person in its path.
- Risk of injury! •
~ehicle care irechnical data
To Next Page
Loading...
