18
Division of functions
System control is broken down into three basic
modules:
– the control unit for access and
start authorisation J518,
– the antenna read-in unit for keyless access
authorisation J723 and
– the switch for access and
start authorisation E415.
All three components communicate with each other
over a local single-wire bus.
The control unit for access and start authorisation is
the master of the system and a participant on
Convenience. The same control unit is installed for
all system versions.
The antenna read-in unit for keyless access
authorisation is only installed with the
Advanced Key option. It serves as the interface
between the antennae, sensors and the control unit
for access and start authorisation.
The switch for access and start authorisation is
installed in various versions, depending on the
transmission, radio frequency of the central locking
system and the Advanced Key option. An evaluation
electronic device is also integrated into the switch.
Convenience electrics
326_064
Access and
start authorisation
J518
Antenna read-in
unit for
keyless access
authorisation
J723
Switch for
access and start
authorisation
E415