42
Functions
The main function of the control unit for on-board
power supply is to read in switch information and
activate power outputs.
It is familiar from the Audi A8 ‘03 and has been
adapted to new functionalities in the Audi A6 ´05.
Master functions
The following master functions are implemented in
the control unit for on-board power supply.
– External lighting control
– LIN master for the control unit for
wiper motor J400
– LIN master for the sensor for rain and
light detection G397 (for details of function,
see Sensor for rain and light detection)
Stand-by master function
If the central control unit for the convenience
system J393 fails, the control unit for on-board
power supply J519 takes over the stand-by master
function. It sends the information for direction
indicators to the CAN bus.
Convenience electrics
326_107
Reference
Further information on this can be found in the
SSP 288, Audi A8 ’03 – Distributed Functions.
326_108
Control unit for on-board power supply J519
J519
G397 J400
To Next Page
Loading...
