Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
14 - Electrical connectors
❑ Assignment of connectors ⇒ page 10
15 - Camshaft control valve 2 -N208-
Fitting location ⇒ page 14
16 - Lambda probe 2 -G108-
❑ With Lambda probe heater 2 -Z28-
❑ Fitting location ⇒ page 11
❑ Fitting location of connector ⇒ page 10
❑ Removing and installing ⇒ page 44
17 - Left electrohydraulic engine mounting solenoid valve -N144-
❑ Fitting location ⇒ page 16
18 - Ignition coils for cylinder bank 2
❑ Ignition coil 4 with output stage -N292-
❑ Ignition coil 5 with output stage -N323-
❑ Ignition coil 6 with output stage -N324-
❑ Removing and installing ⇒ page 53
19 - Valve for oil pressure control -N428-
❑ Fitting location ⇒ page 14
20 - Secondary air pump motor -V101-
❑ Fitting location ⇒ page 15
21 - Charge air cooling pump -V188-
❑ Fitting location ⇒ page 14
22 - Continued coolant circulation pump -V51-
❑ Equipment version or country-specific version
❑ Fitting location ⇒ page 15
23 - Hall sender 2 -G163-
❑ Fitting location ⇒ page 14
24 - Intake manifold temperature sender 2 -G430- / charge pressure sender 2 -G447-
❑ Fitting location ⇒ page 13
25 - Coolant valve for cylinder head -N489-
Fitting location of engine control unit -J623-
♦ -Item 2- in centre of plenum chamber
Audi A8 2010 ➤
Simos direct petrol injection and ignition system (6-cyl. 3.0 ltr. TFSI 4-valve) - Edition 12.2011
2. Injection system 9
To Next Page
Loading...
