Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
1 - Coolant temperature send‐
er -G62-
❑ Fitting location
⇒ page 14
2 - Intake manifold flap poten‐
tiometer 2 -G512-
❑ Fitting location
⇒ page 13
3 - Fuel pressure sender -
G247-
❑ Fitting location
⇒ page 12
❑ Lubricate threads
❑ 22 Nm
4 - Knock sensor 2 -G66-
❑ Fitting location
⇒ page 12
❑ Fitting location of con‐
nector ⇒ page 10
5 - Injectors, cylinder bank 2
❑ Injector, cylinder 4 -
N33-
❑ Injector, cylinder 5 -
N83-
❑ Injector, cylinder 6 -
N84-
❑ Removing and installing
⇒ page 30
6 - Secondary air inlet valve -
N112-
❑ Fitting location
⇒ page 15
7 - Intake manifold flap valve -N316-
❑ Fitting location ⇒ page 15
8 - Secondary air inlet valve 2 -N320-
❑ Fitting location ⇒ page 15
9 - Regulating flap control unit -J808-
❑ Fitting location ⇒ page 12
❑ Removing and installing ⇒ page 27
10 - Lambda probe 2 after catalytic converter -G131-
❑ With Lambda probe 2 heater after catalytic converter -Z30-
❑ Fitting location ⇒ page 11
❑ Fitting location of connector ⇒ page 10
❑ Removing and installing ⇒ page 44
11 - Engine fault warning lamp
❑ In instrument cluster
12 - Accelerator position sender -G79- and accelerator position sender 2 -G185-
❑ In accelerator pedal module; fitting location ⇒ page 10
13 - Brake light switch -F- / brake pedal switch -F47-
❑ Fitting location ⇒ page 10
Audi A8 2010 ➤
Simos direct petrol injection and ignition system (6-cyl. 3.0 ltr. TFSI 4-valve) - Edition 12.2011
8 Rep. gr.24 - Mixture preparation - injection
To Next Page
Loading...
