Audi A8 2010 - Page 11

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
❑ Fitting location of connector ⇒ page 10
❑ Removing and installing ⇒ page 42
8 - Throttle valve module -J338-
❑ Fitting location ⇒ page 12
❑ Removing and installing ⇒ page 25
9 - Engine control unit -J623-
❑ Fitting location ⇒ page 9
❑ Removing and installing ⇒ page 48
10 - Intake air temperature sender -G42- / intake manifold pressure sender -G71-
❑ Fitting location ⇒ page 13
❑ Removing and installing ⇒ page 25
11 - Sender 1 for secondary air pressure -G609-
❑ USA version only
❑ Fitting location ⇒ page 16
12 - Activated charcoal filter solenoid valve 1 -N80-
13 - Engine speed sender -G28-
❑ Fitting location ⇒ page 15
❑ Removing and installing ⇒ page 56
14 - Knock sensor 1 -G61-
❑ Fitting location ⇒ page 11
❑ Fitting location of connector ⇒ page 10
15 - Injectors, cylinder bank 1
❑ Injector, cylinder 1 -N30-
❑ Injector, cylinder 2 -N31-
❑ Injector, cylinder 3 -N32-
❑ Removing and installing ⇒ page 30
16 - Temperature sender for engine temperature regulation -G694-
❑ Fitting location ⇒ page 12
17 - Intake manifold flap potentiometer -G336-
❑ Fitting location ⇒ page 13
18 - Hall sender -G40-
❑ Fitting location ⇒ page 13
19 - Fuel metering valve -N290-
❑ Fitting location ⇒ page 11
20 - Fuel pressure sender for low pressure -G410-
❑ Fitting location ⇒ page 11
Engine compartment (left-side)
Audi A8 2010 ➤
Simos direct petrol injection and ignition system (6-cyl. 3.0 ltr. TFSI 4-valve) - Edition 12.2011
2. Injection system 7