Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Procedure:
– Unscrew filler cap with dipstick.
– Clean dipstick with a clean cloth.
– Screw cap on hand tight and unscrew again.
– Check fluid level according to scale on dipstick.
– If fluid level does not meet specification: Perform following
measures as appropriate:
Fluid level: Measure:
Above specified level Extract hydraulic fluid.
Below specified level Check hydraulic power steering system for leaks ⇒ Running gear, front-wheel
drive and four-wheel drive; Rep. gr. 48 ; Hydraulic power steering; Checking
steering system for leaks .
3.49 Cooling system: checking anti-freeze
protection and coolant level, and cor‐
recting if necessary
WARNING
Coolant expansion tank under pressure - risk of injuries!
♦ Only open coolant expansion tank when engine is cold.
Audi A8 2010 ➤
Maintenance - Edition 11.2014
100 3. Maintenance
To Next Page
Loading...
