Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
3.16 Tyre Pressure Loss Indicator: storing
changed tyre pressures
WARNING
Risk of injury as engine of high-voltage vehicle can start un‐
expectedly!
♦ Observe warnings for high-voltage system:
♦ For work that must be performed with the ignition switched
on ⇒ page 11 .
The Tyre Pressure Loss Indicator must be initialised after every
time the tyre pressures are changed or the tyres are renewed.
Requirements:
• The inflation pressures of all tyres must be adjusted to the
correct values before the pressures are stored.
Procedure:
– Switch on ignition and activate MMI.
– Press function selector button CAR .
– Under »Car systems«, navigate through following menu struc‐
ture:
♦ Servicing & checks
♦ Tyre pressure monitoring
♦ Store tyre pressures
– Use MMI rotary pushbutton to select option to store tyre pres‐
sures.
3.17 Tyre repair kit: checking that set is com‐
plete, and checking and recording expi‐
ry date
The tyre repair kit is located under the luggage compartment floor.
Procedure:
– Check that the following components of the tyre repair kit are
present:
♦ Compressor
♦ Tyre filler bottle incl. filler hose
– Take out the bottle and check the expiry date (printed on bottle
-arrow-).
– Record expiry date in Maintenance table.
– If expiry date has been exceeded or if bottle has already been
used: Renew tyre filler bottle.
Audi A8 2010 ➤
Maintenance - Edition 11.2014
46 3. Maintenance
To Next Page
Loading...
