Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Procedure for removing:
– Remove quick-release fasteners -5- and -6- from connection
between wheel housing liner and noise insulation.
– Remove quick-release fasteners -4- from noise insulation
(front) -3-.
– Unscrew quick-release fasteners -2- and -7-.
– Detach noise insulation (rear) -1-.
Procedure for installing:
Install in reverse sequence. Note tightening torques (see table of
tightening torques for installation ⇒ page 19 ).
Note
Ensure that you feel the quick-release fasteners engage when
installing.
2.4 Window regulators: activating automatic
open/close function
WARNING
Risk of injury as engine of high-voltage vehicle can start un‐
expectedly!
♦ Observe warnings for high-voltage system:
♦ For work that must be performed with the ignition switched
on ⇒ page 11 .
If the vehicle battery was disconnected, the automatic open/close
function for the electric windows must be reactivated.
Procedure:
– Pull up on window regulator switch until windows are com‐
pletely closed.
– Release switch and pull on it again for at least one second.
– Repeat procedure with all window regulators.
2.5 Vehicle diagnostic tester: connecting
WARNING
Risk of injury as engine of high-voltage vehicle can start un‐
expectedly!
♦ Observe warnings for high-voltage system:
♦ For work that must be performed with the ignition switched
on ⇒ page 11 .
Special tools and workshop equipment required
Audi A8 2010 ➤
Maintenance - Edition 11.2014
20 2. Preparations
To Next Page
Loading...
