Audi A8 2010 - Page 23

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Table of tightening torques for installation:
Component/fastener [Nm]
Bolts -7- 2.5
Procedure for removing:
– Unscrew quick-release fasteners -1-, -2-, -3-, -5- and -6-.
– Remove bolts -7- from connection between wheel housing lin‐
er and noise insulation (front).
– Pull noise insulation -4- towards rear out of bottom section of
bumper cover and detach.
Procedure for installing:
Install in reverse sequence. Note tightening torques (see table of
tightening torques for installation ⇒ page 19 ).
Note
♦ Ensure that you feel the quick-release fasteners engage when
installing.
♦ On vehicles with supplementary heater, opening of exhaust
pipe must be routed vertically through grommet in noise insu‐
lation.
2.3.2 Noise insulation (rear)
Special tools and workshop equipment required
♦ Torque screwdriver - V.A.G 1624- , measuring range 1 to 5
Nm
♦ Or: torque screwdriver - VAS 6494- , measuring range 1.5 to
3 Nm
Table of tightening torques for installation:
Component/fastener [Nm]
Bolts -7- 2.5
Audi A8 2010 ➤
Maintenance - Edition 11.2014
2. Preparations 19