EasyManua.ls Logo

Audi A8 2010 - Poly V-Belts for Ancillaries: Checking

Audi A8 2010
142 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Read off and evaluate oil level on display.
If necessary, correct oil level:
Oil level Evaluation/measure
At “max” Drain engine oil until level meets optimum level.
Just under “max” Optimum oil level.
Significantly under “max” Fill up engine oil to optimum level (close bonnet to refresh oil level display).
Note
The oil level display on the MMI is not refreshed when the
bonnet is open.
A warning lamp in the driver information system indicates that
the level is too low.
3.46 Poly V-belts for ancillaries: checking
Caution
Risk of engine damage if camshaft drive slips.
Turn crankshaft only in normal direction of engine rotation.
This maintenance item only applies to certain countries: Note
specification in Maintenance table.
12-cyl. petrol engine 6.3 ltr. FSI ⇒ page 81
8-cyl. diesel engine 4.2 ltr. TDI ⇒ page 83
3.46.1 12-cyl. petrol engine 6.3 ltr. FSI
Special tools and workshop equipment required
Audi A8 2010 ➤
Maintenance - Edition 11.2014
3. Maintenance 81

Table of Contents

Other manuals for Audi A8 2010

Related product manuals