Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
3.41 Engine oil: draining
Note
♦
Oil should always be changed when engine is warm.
♦
Always observe the relevant environmental regulations for
disposal.
♦
Keep components clean.
8-cyl. petrol engine 4.0 ltr. TFSI ⇒ page 67
12-cyl. petrol engine 6.3 ltr. FSI ⇒ page 68
3.41.1 8-cyl. petrol engine 4.0 ltr. TFSI
Special tools and workshop equipment required
♦ Used oil collection and extraction unit - V.A.S 6622 A-
♦ Torque wrench - V.A.G. 1410- , measuring range 4 to 20 Nm
♦ Or: torque wrench - VAS 6583- , measuring range 3 to 60 Nm
Table of tightening torques for installation:
Component/fastener [Nm]
Oil drain plug on sump 20
Oil drain plug on oil filter cover 4
Removal steps:
– Remove noise insulation ⇒ page 18 .
Procedure:
– Place oil drip tray under engine sump.
Audi A8 2010 ➤
Maintenance - Edition 11.2014
3. Maintenance 67
To Next Page
Loading...
