Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Unscrew oil drain plugs -arrows- of sump and in oil filter cover
-1-.
– Drain engine oil from oil filter housing and sump.
– Renew seals of both oil drain plugs.
– Re-install both oil drain plugs and tighten to specified torque
(see table of tightening torques for installation ⇒ page 67 ).
3.41.2 12-cyl. petrol engine 6.3 ltr. FSI
Special tools and workshop equipment required
♦ Used oil collection and extraction unit - V.A.S 6622 A-
♦ Torque wrench - VAS 6583- , measuring range 3 to 60 Nm
♦ Or: torque wrench - V.A.G 1331- , measuring range 6 to 50
Nm
♦ Or: torque wrench - VAS 5820- , measuring range 20 to 100
Nm
Table of tightening torques for installation:
Component/fastener [Nm]
Oil drain plug on sump 30
Removal steps:
– Remove noise insulation ⇒ page 18 .
Procedure:
– Place oil drip tray under engine sump.
Audi A8 2010 ➤
Maintenance - Edition 11.2014
68 3. Maintenance
To Next Page
Loading...
