Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
2.2.9 6-cyl. diesel engine 3.0 ltr. TDI (version
2)
Procedure for removing:
– Carefully pull engine cover panel off retaining pins one after
another -arrows-.
Procedure for installing:
– Position engine cover panel on retaining pins and then use
your hands to press it onto retaining pins, one after the other.
Note
There is more than one version of the engine cover panel for the
6-cylinder 3.0 ltr. TDI diesel engine ⇒ page 17 .
2.2.10 8-cyl. diesel engine 4.2 ltr. TDI
Procedure for removing:
– Carefully pull engine cover panel off retaining pins one after
another -arrows-.
Procedure for installing:
– Position engine cover panel on retaining pins and then use
your hands to press it onto retaining pins, one after the other.
2.3 Noise insulation: removing and installing
DANGER!
Risk of fatal injury if high-voltage components are damaged.
♦ Observe warnings for high-voltage system:
♦ For work in the vicinity of high-voltage components
⇒ page 10 .
Noise insulation (front) ⇒ page 18
Noise insulation (rear) ⇒ page 19
2.3.1 Noise insulation (front)
Special tools and workshop equipment required
♦ Torque screwdriver - V.A.G 1624- , measuring range 1 to 5
Nm
♦ Or: torque screwdriver - VAS 6494- , measuring range 1.5 to
3 Nm
Audi A8 2010 ➤
Maintenance - Edition 11.2014
18 2. Preparations
To Next Page
Loading...
