Audi A8 2010 - Work That Must Be Performed with the Ignition Switched Off

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Note
♦ Certain qualifications are required to perform different types of
work on high-voltage vehicles ⇒ Basic information on high-
voltage vehicles; Rep. gr. 00 ; Qualification of internal/external
personnel .
♦ Note distinguishing features of Audi high-voltage vehicles, de‐
scription of high-voltage technology etc. ⇒ Basic information
on high-voltage vehicles; Rep. gr. 00 ; Distinguishing features
of Audi high-voltage vehicles .
♦ Overview of high-voltage components and wires ⇒ page 8 .
1.6.5 Work that must be performed with the
ignition switched off
WARNING
Safety hazard: the engine can start unexpectedly.
Before carrying out general work on a vehicle with high-voltage
electrical system, switch off the ignition and remove the ignition
key from the vehicle.
Note
♦ Certain qualifications are required to perform different types of
work on high-voltage vehicles ⇒ Basic information on high-
voltage vehicles; Rep. gr. 00 ; Qualification of internal/external
personnel .
♦ Note distinguishing features of Audi high-voltage vehicles, de‐
scription of high-voltage technology etc. ⇒ Basic information
on high-voltage vehicles; Rep. gr. 00 ; Distinguishing features
of Audi high-voltage vehicles .
♦ Overview of high-voltage components and wires ⇒ page 8 .
Audi A8 2010 ➤
Maintenance - Edition 11.2014
12 1. General information