Audi A8 2010 - Page 57

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Cleaning and lubricating the roof insert is a repair measure and
should be charged separately.
Protect vehicle interior from becoming dirty.
Step 1 - cleaning and lubricating glass panel seal:
– Tilt open glass panel at rear.
– Remove all accessible grease and dirt residue from glass pan‐
el seal using cleaning solution - D 009 401 04- and a lint-free
cloth.
– Use a fine-pored sponge -1- to lubricate sides and rear of glass
panel seal -arrows- with Krytox lubricating paste - G 052 141
A2- . Make sure that no coarse residue remains visible after
applying lubricant.
– Open glass panel completely.
– Using cleaning solution - D 009 401 04- and a lint-free cloth,
remove any grease or dirt residue from front of glass panel
seal in area that has not been lubricated yet.
– Use a fine-pored sponge -1- to lubricate glass panel seal at
front -arrow- with Krytox lubricating paste - G 052 141 A2- .
Make sure that no coarse residue remains visible after apply‐
ing lubricant.
Step 2 - cleaning and lubricating guide rails:
Glass panel opened completely.
– First use an industrial vacuum cleaner to remove any loose
residue from guide rails.
– Remove grease and dirt from guide rails with a lint-free cloth.
Audi A8 2010 ➤
Maintenance - Edition 11.2014
3. Maintenance 53