Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
♦ Puller - T40039-
♦ Torque wrench - VAS 6583- , measuring range 3 to 60 Nm
Table of tightening torques for installation:
Component/fastener [Nm]
Spark plugs 30
Securing bolts for connector rail 5
Removal steps:
– Remove engine cover panel ⇒ page 15 .
Step 1 - removing spark plugs:
– Unplug electrical connectors -arrows- from actuators for cam‐
shaft adjustment.
– Unscrew bolts for connector rail.
– Release connectors for ignition coils -arrows- and unplug all
connectors from ignition coils at the same time.
– Place connector rail slightly to one side. Make sure that wiring
is not kinked or damaged.
Audi A8 2010 ➤
Maintenance - Edition 11.2014
86 3. Maintenance
To Next Page
Loading...
