EasyManua.ls Logo

Audi A8 D5 - Page 25

Audi A8 D5
72 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
5.6.4 Disposal of non-triggered pyrotechnic
components
Airbags,
seat belts,
pyrotechnic battery isolation elements,
and the triggering unit for the active front lid/bonnet
must be disposed of in their original packaging and in accordance
with national regulations. Please contact your regional office or
your Importer if you have any questions.
Note
Pyrotechnic components ignited in an accident can be disposed
of together with commercial refuse.
WARNING
This does not apply to Wankel-type belt tensioners.
These must be treated in the same way as pyrotechnic com‐
ponents which have not been triggered, as it is not possible to
use workshop equipment to check whether all stages have
been triggered.
5.6.5 Restraint systems (airbag systems)
Always refer to the Workshop Manual for the relevant vehicle
when working on airbag systems. Refer to ⇒ General body re‐
pairs, interior; Rep. gr. 69 ; Airbag system; Overview of fitting
locations - airbag system , as well as the corresponding safety
precautions General body repairs, interior; Rep. gr. 00 ; Safety
precautions; Safety precautions when working on pyrotechnic
components .
WARNING
The battery earth strap must be disconnected when work‐
ing on the airbag system and when performing straight‐
ening work during body repairs.
Switch on ignition before connecting battery.
There must be nobody in the vehicle when connecting the
battery!
Airbag components must not be subjected to tempera‐
tures above 100 °C, even for a very brief period.
Airbag components must not come into contact with
grease, cleaning agents, oil or similar.
Airbag components with mechanical damage must be re‐
newed.
Wash hands after touching airbag units which have been
triggered.
General InformationBody Repairs, General Body Repairs - Edition 04.2018
5. Assessing damage 21

Table of Contents

Related product manuals