Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Now apply heat to the affected area using a hot air blower until
the dent can be pressed out with a suitable tool.
– Lightly sand down the dented area with abrasive paper (120
grade).
– Then clean the repaired area with cleaning fluid. Allow to dry
for 5 minutes.
– Spray on a thin coat of primer and allow to dry for 10 minutes.
– Now you can fill any remaining surface irregularities with ad‐
hesive and smooth down with a scraper.
– The hardening process can be speeded up with the aid of an
infra-red lamp. Set to 15 minutes at 60°-70°C.
– Now rub down the repaired surface with sandpaper (120
grade).
– Remove sanding dust.
– Spray on a thin coat of primer and allow to dry for 10 minutes.
– Apply paint finish as specified in the Audi paintwork manual.
12.2 Repairing scratches
General InformationBody Repairs, General Body Repairs - Edition 04.2018
12. Plastic repairs 59
To Next Page
Loading...
