Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Riveting procedure
A - Apply rivet
B - Pressing-in procedure
C - Setting and punching out
D - Finished Kerb-Konus riveted joint
Equipment
Only equipment which is listed as approved in the workshop
equipment catalogue may be used.
7.3 Overview of riveting attachments (pairs
of tools)
Note
♦
This list is intended for general information. Please refer to the
operating instructions provided for a description of the proce‐
dure and areas of application.
♦
To increase the life of the riveting attachments, please use
cutting oil (commercially available).
General InformationBody Repairs, General Body Repairs - Edition 04.2018
7. Cold joining techniques 37
To Next Page
Loading...
